KTI Networks KS 2028 Manual de usuario Pagina 1

Installation GuideKTI 10/100 Fast Ethernet SwitchKS2028P/N:750-0087-001DOC.971005-KS2028-K

Rack MountingFor mounting the switch into a 19-inch rack, a pair of mount brackets isincluded in the pack.Figure 2-2 Install Rack Mount BracketsInstal

2.3 Front Panel and Rear PanelFigure 2-4 Components on the Front and Rear Panel• Eight 10BASE-T switched ports (Port #1 to Port #8)Each port consists

• Diagnostic LED indicatorsThe indicators provide the operating status of the hub and thenetwork ports. The status includes power, partition, duplex,a

Figure 2-6 100BASE-FX Port ModuleBefore installing any optional modules, first turn the power to the switchoff. To install a module into the expansion

2.5 Setting the Configuration SwitchesOpen the configuration switch cover on the rear of the unit. There aretwo switch groups as illustrated below:Fig

When a operation mode is accepted by the remote device, the mode is used forthe data transfer between the port and the connected device. Full-duplex o

3. Making Network Connections3.1 Network Switched PortsThere are ten ports on the switch for connection to ten LAN segments.Each segment is an indepen

3.2 10BASE-T Switched PortsThe individual RJ-45 connectors of Port #1 to Port #7 are defined as Xtype connectors and have fixed pin assignments as f

The following table lists the devices to which Port #8 can connect :Device connected Crossover SW Cable usedComputer 10BASE-T port X setting Cat. 3, 5

3.3 10/100BASE-TX Switched PortsThis section applies to the 10/100BASE-TX Port #9 and expansion slotPort #10 pre-configured with a 10/100BASE-TX port

Ó 1997 KTI Networks Inc. All rights reserved. No part of this docu-mentation may be reproduced in any form or by any means or used tomake any directi

3.4 100BASE-FX ModuleThe 100BASE-FX port module supports a connection to a Fast Ethernetnetwork segment through a fiber optic connection. The module c

4. LED Indicators4.1 LED PanelThe switch provides comprehensive LED indicators for diagnosing andmonitoring the operation of the unit as illustrated b

10/100 Fast Ethernet SwitchInstallation GuideDOC.971006-KS2028-NKP/N: 750-0087-002

The information contained in this document is subject to change without prior notice.Copyright Ó KTI. All Rights Reserved.TRADEMARKSEthernet is a reg

Table of Contents1. Introduction ... 11.1 Features ...

1. IntroductionDriven by recent advances in desktop computing technology, today’snetwork applications have grown speed, power and the ability to pro-c

1.1 FeaturesDesigned for resolving congestion problems caused by bandwidth-hun-gry devices and bandwidth-intensive applications as well as a high num-

1.2 SpecificationsNetwork ports 10BASE-T ports 810/100BASE-TX port 1Expansion port slot 1Filtering rate 10BASE-T ports 14,880 pps10/100BASE-TX port 14

2. Installing the SwitchThe switch is designed to operate in workgroup environments without acomplicated configuration procedure. It also features an