KTI Networks KPOE-800-2P Manual de usuario

Modular 8-Port Mid-span Power over Ethernet Injector KPOE-800-1P KPOE-800-2P Installation Guide 1 DOC.090201

2.3 Mounting the Injector Desktop Mounting The injector can be mounted on a desktop or shelf. Make sure there is proper heat dissipation from and adeq

2. Install the long bracket to the other side of the device. 3. Mount the device in a 19” rack. Mounting two units in a rack Use the bracket set 2

3. Mount two device units as one in a 19” rack. 2.4 Installing Power Module If you purchased 2 Power Model, you may skip this section. 1 Power Mod

3. Install the power module into the slot until it is seated properly. 4. Screw the module in the injector securely. 2.5 Applying AC Power One AC p

3. Making LAN Connections 3.1 Making Switch Port Connections The mid-span injector is designed to support the following PoE incapable switch port typ

3.2 Making Powered Device Connections The mid-span injector supports connection to IEEE 802.3af compliant PoE PD (Powered Device). The Ethernet port o

Short-circuit A short-circuit situation is detected on the port. Under voltage An under-voltage situation is detected on the port. 3.3 LED Indi

4. Applications 4.1 Application with Low Power Requirements 1 Power model may be used if the total power budget of the connected PDs is less than 60W

(C) 2008 KTI Networks Inc. All rights reserved. No part of this documentation may be reproduced in any form or by any means or used to make any direct

The information contained in this document is subject to change without prior notice. Copyright (C) All Rights Reserved. TRADEMARKS Ethernet is a reg

Table of Contents 1. Introduction ...

1. Introduction The Power over Ethernet (PoE) injector is a mid-span power injector designed and tested for use with all IEEE802.3af compatible PoE

 Modular PoE power upgradability  19" rack mounting support 1.2 Product Panels The following figure illustrates the faces of the injector:

1.4 Model Definition KPOE-800-1P 1 Power Model The injector unit with one pre-installed power module KPOE-800-2P 2 Power Model The injector unit

8 - Disconnection, - Overload, - Over-current - Short-circuit, - Under voltage Power Module Slots 2 LED Indicators Power module status x

9 2. Installation 2.1 Unpacking Check that the following components have been included:  Information CD  The device unit  An AC power cord If any